by Tobias | Jul 20, 2015 | DER Blog
During the planning stages of this project, we had come up with a few strategies to create a thick layer of insulation and a primary air barrier using dense-packed cellulose and a fabric such as Pro Clima’s Mento Plus. Using this type of system, it is possible...
by Tobias | Jul 17, 2015 | DER Blog
IMG_0609_smRemoving the Old IMG_0608_smNew Frame goes in IMG_0610_smDon’t Insulate this Way! IMG_0606_smNew Roof Liine Once the decision was made to rip off the old roof and replace it with new, we just needed to figure out the details. This involved a little...
by Tobias | Jul 17, 2015 | DER Blog
Once the floor system was stabilized, it was time to see what was going on with the roof. In years past, we had a few problems with ice dams. Ice dams are caused when snow on the roof is melted by warm, interior air temperatures. The now-liquid water flows down the...
by Tobias | Apr 6, 2015 | DER Blog
After we exposed the rim joist, we found a few other deficiencies. We jacked and straightened the rim joist (more of a beam in this case). The rim joist was made up of a double 2×8, this was not strong enough to support the loads between the piers, so we would...
by Tobias | Apr 4, 2015 | DER Blog
So… as indicated by the condition of the plywood we had some rot at the bottom plate and rim joist. We had some friendly neighborhood carpenter ants in there as well. This is a good example of how quickly a small maintenance issue can turn into a much larger,...
Recent Comments